materials are uniformly put on the mesh-belt by the feeder. The mesh-belt uses generally 12-60 mesh stainless steel wire net and it is drawn and moved inside the drier by a transmission device. The drier is composed of several units. For each unit, the hot air is circulated separately. Some exhausted gas is discharged with a special moisture elimination blower. The waste gas is controlled through an adjustment valve. The hot air passes through the mesh-belt covered with the material from the top to the bottom or from the bottom to the top and this will complete the heat and mass transfer process.
The materials are uniformly distributed on the mesh-belt by the material feeder. The mesh-belt generally
adopts 12-60 mesh stainless steel mesh and it is drawn by a transmission device and move inside the dryer .
The dryer is composed of several sections. For each section, the hot air is circulated separately.
Part of exhausted gas is exhausted by a special moisture exhaust blower. The waste gas is controlled
by an adjustment valve. The hot air passes through the mesh-belt covered with bring water material away.
The mesh-belt moves slowly, running speed can be freely adjusted according to the material property.
The final products after the drying process will fall into the material collector continuously.
The pre-sales service
To provide you with the project and process design, make suitable plan for you, or design and manufacture theconveyor mesh belt drying equipmentaccording to your special needs.
The sales of service
To accompany you to complete theconveyor mesh belt dryerinspection and acceptance, assist to draft the construction scheme and detailed process.
The after-sales service
We will send the technical personnel to guide the installation and the commissioning of the machine.
Copyright © 2017 - 2023Pasta Drinking Straws Making Machine Manufacture All Rights Reserved